Fred Soll Incense
- Light the tip of the incense with a match.
- Blow out quickly in 2 or 3 seconds.
- Continue with this procedure until a “glow” appears. This will help the resin not to bubble, drip or put itself out.
- Place horizontally in an ash catcher.
- Keep out of direct sunlight.
Occasionally, Fred’s incense may stop burning. We do not add chemicals to help it burn. Just relight and enjoy!!
(Use rubbing alcohol to remove resin off of your hands.)
Incense has been burned by people, on altars and in homes for over 5,000 years. In ancient times it was a feature of sacrificial religious ceremonies. It was used in early Judiasm and, later by the Romans for religious and state ceremonies. Incense was also used by most Asian religions, the Anglican, Roman Catholic, and Orthodox churches.
There are four basic types of incense – loose, cone, cylinder or stick. They are built from fragrant materials, usually consisting of aromatic gums and spices that produce a fragrant smoke when burned. Scent choices come from berries, bark, flowers, gums, roots, leaves, seeds, spices, and wood. Some herbs do not burn like they smell. There lies the skill of the incense artist – Fred Soll®.
Today many people are searching for natural remedies for stress and illnesses. Aromatherapy, although a modern term, has been used for thousands of years for healing. Scientists have shown that many plant essences can produce a calm, relaxed state of mind. Herbs are commonly used to treat the symptoms of PMS and depression.
Fred Soll’s® Quality Ingredients
Fred uses plant and tree resins, herbs, powders, and oils to produce this high quality incense. Fred Soll’s ® resin incense is handmade, hand dipped and dried in Tijeras, New Mexico. Tijeras is 10 miles east of Albuquerque, off of I-40.
Natural Pinon resins – Harvested in the forests of New Mexico, these resins provide the natural base to bond nature’s ingredients to the incense sticks.
Amber resin – Is a crystallized mixture of resins native to India and the Middle East. It has been known as the King of Scents, while Rose is its companion as Queen Mother.
Frankincense – Truly for the connoisseur. The Frankincense resin is obtained from the leafy forest tree – Boswellia Thurifera. The trees grow on the coast of Somali (Arabia) without soil, but out of polished rocks. They attach themselves to the rocks with a thick oval mass of substances resembling a mixture of lime and mortar. The young trees furnish the most valuable gum. The Frankincense is harvested through creation of a deep longitudinal incision made in the trunk of the tree. Below the incision, a narrow strip of bark 5 inches in length is peeled off. After a milk like juice weeps from the tree and is hardened by exposure to the air, the incision is deepened. After approximately three months time, the resin hardens into a usable consistency of yellowish “tears”. The large, clear globules are scraped off into baskets. They are gathered from May until mid-September when the first rains arrive. Frankincense is known for its stimulating qualities.
Myrrh – The bushes yielding the Myrrh resin grow no higher than 9 feet. They are sturdy with knotted branches and branchlets that stand out at right angles, ending in a sharp spine. The plant was fist discovered in Ghizan on the Red Sea coast. This district is so bare and dry that it is called “Tehama” meaning “Hell”.
The ducts in bark of the bushes and the tissues beneath break down forming large cavities. These become filled with a granular secretion. It flows as a pale yellow liquid and then hardens to a reddish-brown mass. In commerce they are seen in “tears” of many sizes – average is that of a walnut. Myrrh is used as an astringent and for healing as a tonic and stimulant. It is also used as an expectorant to stimulate the mucous tissues and for appetite.
Recently viewed products
Fred Soll Incense
Best on the market.